Product description
Most of these bolts are replaced by the many damages caused by tightening and loosening with the wrong tool (the use of a hammer and chisel is very popular). Secure the flywheel with a clamp and locking bar and loosen the bolt(s) with the appropriate socket wrench. If you follow this procedure, you do it correctly without damaging the bolt or bolts.
The bolts used on a Type 4, WBX and Diesel engine cannot be reused. These are tension bolts which may not be reused once they have been tightened to the correct torque. With the Type 4 engine you should also take care to replace the locking plate (see tab options), this is also for one-time use only.
With type 1, type 3 and CT/CZ motors, the flywheel bolt is equipped with the gearbox primary shaft bearing, if this bearing is worn you can replace it separately (see replacement parts tab) but it is much easier to mount a complete bolt with the bearings. Before mounting a new bolt, make sure that the bearing is lubricated with the correct grease (see options tab) and that the felt seal does not lock on the main drive. If this is the case, the seal may come off, which can cause gear shifting problems. If necessary, enlarge the felt a little.
Stock gland nut including pilot bearing
15 items in stock
€13.85 (Each)
Prices incl. VAT
- Order before 3PM (CET)? Shipped the same day!
- Any questions? We're reachable until 17h (CET).
- VW specialist since 1989
- 30 days return period
Type-1 engine 30hp
Do you want to know where this part belongs? Consult the exploded view drawing.
View drawingSpecifications
| Paruzzi number | 2091 |
|---|---|
| Original VW number | 111105305C |
| Brand | Paruzzi |
| Freight | No |
Share:
Complete your order:
- Applicable on Type-1 engines | Type-3 engines | Type-4 engines | CT/CZ engines | Waterboxer engines
- Paruzzi number: 1113
11 items available
incl. vat
- Paruzzi number: 1124
32 items available
incl. vat
- Applicable on Type-1 engine | Type-3 engine | CT/CZ engine
- Paruzzi number: 2097
- Original VW number: 111105297
114 items available
incl. vat
- Applicable on Type-1, Type-3, CT/CZ engine flywheel | Beetle, Karmann Ghia, Type 3, Thing all and Bus until 7.1963 axle nut
- Paruzzi number: 4111
- Original VW number: VW163A
Out of stock
incl. vat
- Applicable on Type-1 engines 25hp+30hp
- Paruzzi number: 1645
- Original VW number: 111105245
119 items available
incl. vat
- Applicable on Type-1 engine (inside flywheel bolt) | Type-3 engine (inside flywheel bolt) | Type-4 engine (inside crankshaft) | CT/CZ engine (inside flywheel bolt) | Waterboxer engines (inside crankshaft)
- Paruzzi number: 41535
- Original VW number: 111105313A
31 items available
incl. vat