Product description
If your engine is fitted with a stroker crankshaft, the compression ratio has been altered or the cylinders have been machined, the required pushrod length may change. The original pushrods may then no longer be suitable.
The solution is so-called “blank end” pushrods. These are cut to the correct length and are made from 4130 chrome-molybdenum steel, making them considerably stronger than standard pushrods.
Cutting them to length is not a complicated job in itself, but it must be done very accurately. Use a tube cutter and the special length tool for this, see the Options tab. Make sure the tips are pressed into the pushrod perfectly straight. If a tip is fitted at an angle, the pushrod can be damaged and there is a risk that the tip may come loose later, potentially causing serious engine damage.
The Manton chrome-molybdenum pushrods all have the same 3/8 inch outside diameter. The difference between the versions is the wall thickness. The thin-wall version has a wall thickness of 0.035 inch, approximately 0.89 mm. The thick-wall version has a wall thickness of 0.058 inch, approximately 1.47 mm.
Thin wall
The model listed here is the thin-wall version. It is lighter and therefore particularly suitable for standard engines and lightly to moderately tuned engines. The lower weight helps to keep the moving mass in the valvetrain to a minimum. At the same time, you benefit from the strength and dimensional stability of a chrome-molybdenum pushrod. This version is a good choice when valve spring pressure and valvetrain loads are not extreme and low weight is important.
Thick wall
The thick-wall version can be found under the Other models tab. It has the same outside diameter, but the greater wall thickness results in a smaller inside diameter. This makes the pushrod stiffer and more resistant to bending under higher loads. This version is therefore particularly suitable for more heavily tuned engines, stronger valve springs, more aggressive camshafts and other applications where the valvetrain is subjected to higher loads and additional stiffness is more important than minimum weight.
Which version is most suitable depends on the complete engine setup, such as the camshaft, valve springs, rocker arms, engine speed and the load on the valvetrain.
Note: Never try to straighten bent pushrods and reuse them. Once a pushrod has been bent, it has lost its original straightness and may bend again.
5 items in stock
€253.45 (8 pieces)
Prices incl. VAT
- Order before 3PM (CET)? Shipped the same day!
- Do you have questions? We are reachable until 17h (CET).
- VW specialist since 1989
- 30 days return period
Type 1 engines (except 25 hp and 30 hp engines)
Type 3 engines
Type 4 engines
CT/CZ engines
Waterboxer engines
| Manufacturer | Manton Pushrods |
|---|---|
| Manufacturer address | 558 Birch St 4, Lake Elsinore, CA 92530, USA |
| Manufacturer contact | 558 Birch St # 4 Lake Elsinore, CA 92530, US |
| Rep EU | Paruzzi BV |
| Rep Address EU | Kreeft 16, 4401NZ, Yerseke, Nederland |
| Rep Contact EU | sales@paruzzi.com |
| Country of origin | United States |
Specifications
| Paruzzi number | 4729-102 |
|---|---|
| Brand | Manton |
| Diameter | 9.53 mm |
| Length | 292 mm |
| Wall thickness | 0.89 mm |