Product description
All modern cars today are equipped with electronic ignition, because this type of ignition has many advantages. The installation of this electronic ignition not only has the advantage that the ignition points never have to be replaced, but also has many other advantages :
- you no longer have contact points, so you don't have to adjust the opening angle of the contact points either
- the new setting is always optimal and your fuel consumption decreases
- there are no more moving parts in the ignition, so there is no risk of ignition problems
- assembly is easier and faster than mounting and adjusting the contact points
- after installation, just set the ignition timing and then you never have to look at it again
To be clear: this electronic ignition is mounted in the existing distributor housing and replaces the contact points and the condenser.
Make sure everything is properly connected, as described in the manual, before starting the engine. If the wiring is mounted incorrectly, the unit will fail immediately. The ignition coil must have a minimum resistance of 3.0 ohms, so a working original ignition coil will do, but check this before starting the engine. If the resistance is too low, the ignition coil will overheat and the module may fail. Once connected, the units cannot be returned.
Note: The data listed under "Fits:" is an approximate indication, use the "Distributor / ignition tool" to check that you have selected the correct electronic ignition and do not forget to observe the points of attention listed under "Note".
Electronic ignition
1 items in stock
€215.30 (Each)
Prices incl. VAT
- Order before 3PM (CET)? Shipped the same day!
- Any questions? We're reachable until 17h (CET).
- VW specialist since 1989
- 30 days return period
Beetle 1965-1967
Karmann Ghia 1965-1967
Bus 1964-1967
Type 3 1966-1967
Note:
- only for vacuum advanced distributors
- car electricity must be 12V
- only use coil #2036
- use carbon or spiral core ignition wires
Specifications
| Paruzzi number | 4012 |
|---|---|
| Brand | Pertronix |
Share:
- Applicable on Type-1 engines until 9.1992 | CT/CZ engines
- Paruzzi number: 2033
4 items available
incl. VAT
- Applicable on Type-1 engines until 9.1992 | CT/CZ engines
- Paruzzi number: 2034
2 items available
incl. VAT
- Applicable on all models with conventional ignition points and all models using electronic ignition 2013, 4012, 4013 or 4014 | Note: | Mounting method: straight, as stated in the description
- Paruzzi number: 2036
33 items available
incl. VAT
- Applicable on Type-1 engines until 9.1992 | CT/CZ engines
- Paruzzi number: 2072
3 items available
incl. VAT
- Applicable on Type-1 engines (except 25hp and 30hp engines) | Type-3 engines | CT/CZ engines | Type-4 engines | Note: | For cars with a stock 12V electronic ignition only use coil #2053, #2165 or #2036
- Paruzzi number: 2246
- Original VW number: 123/VWRV
Out of stock
incl. VAT