Product description
If you have not adjusted the valve clearance for a long period of time, the adjustment bolts and/or lock nuts can be very tight and difficult to unlock. Sometimes, cutting and/or damaging the thread is the only solution. In this case, you will need to install new sets of screws and/or lock nuts.
It is also possible that the set screws may be worn at an angle or hammered due to the age of the engine. In this case, the valve clearance can no longer be adjusted correctly, replacing the nuts and adjustment bolts is the only solution.
Different types were used for the different engines. If in doubt, measure the old adjusting screw before ordering. The latter is necessary in CT/CZ engines, two sizes are used in these engines.
Attention! Our adjusting screws and locking nuts are of very high quality, many adjusting screws on the after-market are of very poor quality and will be broken after a few kilometers. It is an important part to keep the valves intact, so don't use cheap alternatives, it can cost you a lot of money.
Note: M8 x 1.0 locknuts have a dual function: they were also used as locknuts for the stabilizer bar bolts on Beetle, Karmann Ghia, VW Thing and Type 3 models fitted with swing axles.
Valve adjustment nuts
11 items in stock
€11.85 (8 pieces)
Prices incl. VAT
- Order before 3PM (CET)? Shipped the same day!
- Any questions? We're reachable until 17h (CET).
- VW specialist since 1989
- 30 days return period
Type-4 engines 1800cc and 2000cc
Specifications
| Paruzzi number | 41725 |
|---|---|
| Original VW number | 028109453 |
| Brand | VW |
| Thread size | M10 x 1.00 |
| Wrench size | 14 mm |
Share:
- Applicable on Type-4 engines
- Paruzzi number: 41773
- Original VW number: 021101481
157 items available
incl. VAT
- Applicable on Type-4 engines 1800 and 2000cc
- Paruzzi number: 41782
- Original VW number: 022109451
45 items available
incl. VAT
