Product description

To limit the suspension travel, stop rubbers can be found on the rear axle, on the pendulum axle* models they are mounted on a separate support. The rubber is pressed onto a bulge located in the center of the support. Moisture and dirt can accumulate there, creating a breeding ground for rust, which attacks the bulge and spontaneously breaks off when the rubber is pulled loose. The only thing you can then do is install a new support. It is advisable to install a set of new rubbers in addition to the support, they will need replacement just as badly as your rusted-out support.

Applicable to the following swing axle* models :
Beetle from August 1964 and later
Karmann Ghia from august 1964 and later
Type 3 all construction years

#1447 left
#1448 right

Option:
Stop rubbers, order these directly with it, you will undoubtedly need them :

#1453 :
Beetle : from august 1959 and later (per pair)
Karmann Ghia : from august 1959 and later (as pair)
Type 3 Pontoon :Fastback all years, Variant from August 1966 onwards (in pairs)

#21454 :
Type 3 Variant : through July 1966 (each)

* swing axles can be recognized by 1 drive sleeve mounted on the gearbox side and with intermediate axles (IRS) they are separate axles (with homokinets) with drive sleeves on both sides.