Product description
This push rod is located underneath the fuel pump and transfers the movement of the engine to the fuel pump.
Checking only the length of the push rod is not sufficient to determine whether the fuel pump is being driven correctly. The final adjustment is determined by the combination of the push rod, the fuel pump stand and the gaskets.
The push rod moves through a stroke of approximately 4 mm while the engine is running. This stroke is determined by the eccentric on the distributor drive. It is important that this complete stroke remains within the correct range above the fuel pump stand.
To check this, fit the fuel pump stand with the two corresponding gaskets and install the push rod. Then rotate the engine and measure how far the push rod protrudes above the stand in its lowest and highest positions.
In the lowest position, the push rod must protrude at least 5 mm above the fuel pump stand, and in the highest position no more than 13 mm. As the stroke is approximately 4 mm, values such as 8 to 12 mm or 9 to 13 mm are correct. There is therefore some tolerance.
Always check these measurements with the actual fuel pump stand and gaskets fitted. The thickness of both the stand and the gaskets can differ from the original and directly affects the final height of the push rod. Therefore, always check the complete combination rather than relying only on the nominal length of the push rod.
Note: The push rod must be able to move freely and smoothly through the fuel pump stand. Always check this before installation. If the push rod moves too tightly through the stand, carefully enlarge the bore slightly with a fine file. The parts can expand further as the engine heats up during driving. If the push rod then becomes stuck, the fuel pump will no longer be driven.
595 items in stock
€2.04 (Each)
Prices incl. VAT
- Order before 3PM (CET)? Shipped the same day!
- Do you have questions? We are reachable until 17h (CET).
- VW specialist since 1989
- 30 days return period
Type-1 engines from 8.1973 onwards
CT/CZ engines
Waterboxer engines
Do you want to know where this part belongs? Consult the exploded view drawing.
View drawing| Manufacturer | Paruzzi BV |
|---|---|
| Manufacturer address | Kreeft 16, 4401NZ Yerseke, Nederland |
| Manufacturer contact | sales@paruzzi.com |
| Country of origin | Brazil |
Specifications
| Paruzzi number | 1668 |
|---|---|
| Original VW number | 113127307A |
| Brand | Paruzzi |
| Length | 100 mm |