When replacing the rear brake shoes, it is usually necessary to transfer the handbrake levers, which are fitted with a pin that is secured with a horseshoe-shaped clamp.
If the pin is damaged, badly rusted or lost, you'll need to replace it, and don't forget to order the horseshoe-shaped clamp, which can be found in the "options" tab.
The horseshoe-shaped pliers must always be replaced, as they are pinched around the pin's notch and are therefore intended for single use only.
Note: There are many reproductions whose dimensions do not match those of the original, so fitting the handbrake lever will not be easy and can sometimes only be carried out after modification. The parts listed here are 100% identical to the original and fit as they should, without modifications or other problems.
Useful information from Paruzzi magazine and from our YouTube channel :
Look for more technical articles on the page Paruzzi Magazine