Passar till: Audi 50 1100cc 8.1975 till och med 7.1978
VW Golf 1100/1300cc 8.1975 till och med 7.1984
VW Sirocco 1100 8.1974 till och med 7.1983
VW Polo 1100 8.1975 till och med 7.1990
Useful information from Paruzzi magazine and from our YouTube channel :
6 volts and 12 volts Until the early 1970s, the VW Beetles were equipped with 6 volts in their 1200 cc version. The 1300 cc Beetle was first equipped with a 12 volt system in 1968. The VW Bus and type 3 VWs were increased to 12 volts in 1967. Types 4 are in 12 volts, as they were only introduced to the market in the late 1960s.
voltage drops The electric consumers of your classic Volkswagen expect the full 6 volts or 12 volts (or more) to function properly, which is unfortunately not always the case. Especially the 6 volt version sometimes complains about slow running windscreen wipers, weak headlights and direction indicators that pinch too slowly.
the condenser explained The condenser is the most misunderstood part of the motor. What is inside that metal cylindrical part? So, what does this part actually do? Is it really necessary for the proper functioning of the engine? In this article we will limit ourselves to explaining what a capacitor is and what it does, and to measuring and testing the condenser.
(dis)assembly of the spark plugs It seems like a simple job, replacing or checking the spark plugs of your VW. Yet we see that it is not always done according to the rules. Spark plugs that are not properly assembled or have been disassembled carelessly can cause a lot of problems with the engine.
Engine overhaul - video 08 ignition time of cylinder 1 In this video we will determine the ignition timing of cylinder 1. This mark will be needed to correctly position the distributor drive shaft during assembly, as well as for ignition advance adjustment once the Type 1 Volkswagen engine is rebuilt.
Engine overhaul - video 04 removing the distributor drive shaft We want to give extra attention in this video to the position of the distributor drive shaft of the VW Type 1 engines, . If the drive shaft of the distributor is not correctly mounted during the engine overhaul, problems can arise later with the adjustment of the ignition timing. Disassembling the drive shaft is then the only solution.
replacing ignition points We will discuss how to adjust the gap between the contact points, also known as the contact angle or Dwell angle. Instead of just discussing the adjustment of the contact points, we will replace them with new ones.
finding the top dead center What does Top Dead Center (TDC) actually mean? If you study the theory of the operation of an internal combustion engine - or the "petrol engine" - it will become clear. Without going into too much detail about the theory, we have to talk about the otto cycle, better known as the four stroke cycle.
ignition timing - dynamic In this edition, we will adjust the ignition with the engine running, this is called a dynamic measurement. VW advises in its workshop manuals this way of adjusting all air-cooled VWs from August 1970 onwards. The static adjustment with a test bulb is then only suitable for a temporary engine adjustment on these young Volkswagens.
the distributor The intention is that we can adjust the ignition of our classic Volkswagen ourselves. First you have to know which parts have an influence on the operation of the ignition and you have to understand how the ignition circuit works, this is very important to be able to make a good diagnosis and to be able to adjust the ignition later on.