Passar till: Audi 50 1100cc 8.1975 till och med 7.1978
VW Golf 1100/1300cc 8.1975 till och med 7.1984
VW Sirocco 1100 8.1974 till och med 7.1983
VW Polo 1100 8.1975 till och med 7.1990
Useful information from Paruzzi magazine and from our YouTube channel :
testing the condenser Without the condenser, the ignition will really not work properly and the contacts will burn in quickly. So it is important to measure at regular intervals if the condenser in your VW motor is still working.
(dis)assembly of the spark plugs It seems like a simple job, replacing or checking the spark plugs of your VW. Yet we see that it is not always done according to the rules. Spark plugs that are not properly assembled or have been disassembled carelessly can cause a lot of problems with the engine.
Engine overhaul - video 04 removing the distributor drive shaft We want to give extra attention in this video to the position of the distributor drive shaft of the VW Type 1 engines, . If the drive shaft of the distributor is not correctly mounted during the engine overhaul, problems can arise later with the adjustment of the ignition timing. Disassembling the drive shaft is then the only solution.
measuring the coil Everyone knows that the capacitor will protect the contact points from burn-in. But what few people know is that the capacitor also plays a very important role in transforming the low voltage of the battery (6V or 12V) into a high voltage (more than 10,000V) needed to create a spark between the electrodes of the spark plug.
Engine overhaul - video 08 ignition time of cylinder 1 In this video we will determine the ignition timing of cylinder 1. This mark will be needed to correctly position the distributor drive shaft during assembly, as well as for ignition advance adjustment once the Type 1 Volkswagen engine is rebuilt.
ignition timing - static In air-cooled Volkswagens from August 1970, the notch in the crankshaft pulley is used to dynamically adjust the ignition timing. The static adjustment with the test lamp is then only suitable for temporary adjustment on younger models.
ignition timing - dynamic In this edition, we will adjust the ignition with the engine running, this is called a dynamic measurement. VW advises in its workshop manuals this way of adjusting all air-cooled VWs from August 1970 onwards. The static adjustment with a test bulb is then only suitable for a temporary engine adjustment on these young Volkswagens.
6 volts and 12 volts Until the early 1970s, the VW Beetles were equipped with 6 volts in their 1200 cc version. The 1300 cc Beetle was first equipped with a 12 volt system in 1968. The VW Bus and type 3 VWs were increased to 12 volts in 1967. Types 4 are in 12 volts, as they were only introduced to the market in the late 1960s.
vacuum advance Both the vacuum advance and the mechanical advance were used for the VW Beetle, Karmann Ghia, VW Bus, VW Thing, type 3 and type 4. You can't stick a year of manufacture or type of engine on it, both systems do the same thing in the end, they bring forward the ignition time depending on the engine speed.
Engine overhaul - video 12 the flywheel In this video, we'll explain how to disassemble and assemble the flywheel, and what tools you'll need to do so. To disassemble the flywheel, you will need to unscrew the gland nut. This nut is attached with a torque of 350 Nm, it will require some force to loosen.