Useful information from Paruzzi magazine and from our YouTube channel :
replacing ignition points We will discuss how to adjust the gap between the contact points, also known as the contact angle or Dwell angle. Instead of just discussing the adjustment of the contact points, we will replace them with new ones.
testing the coil You can easily check if the electrical voltage in the primary circuit of the coil is correct by using a multimeter. High voltage measurement at the secondary circuit cannot be performed with a standard multimeter.
testing the condenser Without the condenser, the ignition will really not work properly and the contacts will burn in quickly. So it is important to measure at regular intervals if the condenser in your VW motor is still working.
6 volts and 12 volts Until the early 1970s, the VW Beetles were equipped with 6 volts in their 1200 cc version. The 1300 cc Beetle was first equipped with a 12 volt system in 1968. The VW Bus and type 3 VWs were increased to 12 volts in 1967. Types 4 are in 12 volts, as they were only introduced to the market in the late 1960s.
radio interference Have you ever driven a classic Volkswagen with an original radio or a classic radio, then you have probably ever known the phenomenon "interference". That annoying noise, buzzing, crackling that comes out of your speakers. These disturbances can have different causes, but they can also be remedied.
Engine overhaul - video 13 replacing the crank seal During a complete engine overhaul, you will need to replace the crank seal. But replacement may also be necessary, when you discover an oil leak behind the flywheel, which will impair the operation of the clutch. We show in this video how to disassemble and reassemble the crank seal.
Engine overhaul - video 07 TDC compression in practice In video six, we explained the operation of the four-stroke internal combustion engine through animations. In this video we will look at how to determine the top dead centre of cylinder 1 in practice. We will also learn how to find the compression stroke of cylinder 1, different techniques will be shown.
the condenser explained The condenser is the most misunderstood part of the motor. What is inside that metal cylindrical part? So, what does this part actually do? Is it really necessary for the proper functioning of the engine? In this article we will limit ourselves to explaining what a capacitor is and what it does, and to measuring and testing the condenser.
Engine overhaul - video 12 the flywheel In this video, we'll explain how to disassemble and assemble the flywheel, and what tools you'll need to do so. To disassemble the flywheel, you will need to unscrew the gland nut. This nut is attached with a torque of 350 Nm, it will require some force to loosen.
finding the top dead center What does Top Dead Center (TDC) actually mean? If you study the theory of the operation of an internal combustion engine - or the "petrol engine" - it will become clear. Without going into too much detail about the theory, we have to talk about the otto cycle, better known as the four stroke cycle.