Useful information from Paruzzi magazine and from our YouTube channel :
air filter thermostat The preheating of the fresh air supplied via the air filter to the carburettor is a part of our VW engine that gets too little attention. This system will ensure that in all weather conditions the carburettor is supplied with air at the right temperature. With these younger air filter models you don't have to adjust anything in contrast to the older models.
Engine overhaul - video 15 disassemble cylinder heads In this video, we will show how to disassemble the cylinder heads of a VW Type 1 engine, and what challenges you may face.
Engine overhaul - video 13 replacing the crank seal During a complete engine overhaul, you will need to replace the crank seal. But replacement may also be necessary, when you discover an oil leak behind the flywheel, which will impair the operation of the clutch. We show in this video how to disassemble and reassemble the crank seal.
HPMX carburetors The most famous double carburettors are the Weber IDF and the Dellorto DRLA. Since a few years there is a new player on the market, namely the HPMX carburettor. This is marketed by EMPI and is also sold as a complete set, including manifolds, air filters, linkage and mounting material.
Engine overhaul - video 10 the crankshaft pulley In this tenth video, we will show how to disassemble and reassemble the crankshaft pulley. We will use special tools for this, standard tools, as well as a homemade pulley puller. If you don't have the right tools and use the right technique, chances are you will warp the crankshaft pulley, you really don't want that. So watch this video carefully before you start this job.
adjust type 1 carburetor The adjustment of the carburetor will determine the behavior of the engine. There are two types of carburetors for the type 1 engine when it comes to adjustment. The old generation (up to SOLEX 30 PICT-2) with two adjusting screws and the young generation with three adjusting screws (from SOLEX 30 PICT-3), recognizable by the large screw in the carburetor housing.
Engine adjustment - video 02 adjusting the rocker arms In the first video of this series, we adjusted the valve clearance. In addition to the valve clearance, the position of the rocker arm relative to the valve stem, is also a very important setting. If a rocker arm is not positioned correctly, it can be adjusted, which is called shimming.
Engine overhaul - video 08 ignition time of cylinder 1 In this video we will determine the ignition timing of cylinder 1. This mark will be needed to correctly position the distributor drive shaft during assembly, as well as for ignition advance adjustment once the Type 1 Volkswagen engine is rebuilt.
Engine adjustment - video 01 valve clearance The valve clearance is the first thing to check when adjusting an engine. If the valve clearance is not adjusted properly, then adjusting for example, the ignition, or the carburetor, will do little good. In this video we will show you how to adjust the valve clearance.
Engine diagnostics - video 03 pushrods In video fourteen of our series on engine overhaul, we disassembled and reassembled the rocker arms and pushrods. In this video, we will inspect the pushrods. The result of this diagnosis, will tell us if we can reinsert the pushrods, or if we need to replace them.