Varorna som visas här är relaterade till varandra med varan du valt och beställs eller söks ofta tillsammans.
Tips: får du ingen bra träff på sökordet du angivit så försök då att söka en vara som är relaterad till den. Finns det då en flik relaterade varor så kanske du hittar varan du sökte där.
Skärmad 6,3 mm spadkontakt 1 till 1
Produktnummer : 4411 Original VW nummer : 111971977
Useful information from Paruzzi magazine and from our YouTube channel :
replacing spade connectors A messy electrical connection will soon lead to the failure of electrical accessories or, in the worst case, the engine. Incorrect connections can also result in short-circuits, causing the wiring harness to burn out. Enough reasons to master a good technique to make the electrical connections of your VW neat and tidy.
alternator operating principle The direct current dynamo greatest asset turned out to be its greatest limitation, the collector. Supplying more current would shorten the life of the carbon brushes; something had to be found for that. So the dynamo no longer sufficed for the new situation of the mid-sixties.
determine cable diameter The older your Volkswagen the more likely it is that the electrical consumers no longer get the full 6 volts or 12 volts due to voltage losses between the battery and the consumer. A voltage drop across the electrical conductor is inevitable, we are dealing with copper and we cannot make the cross section of the cable infinitely large.
voltage drops The electric consumers of your classic Volkswagen expect the full 6 volts or 12 volts (or more) to function properly, which is unfortunately not always the case. Especially the 6 volt version sometimes complains about slow running windscreen wipers, weak headlights and direction indicators that pinch too slowly.
6 volts and 12 volts Until the early 1970s, the VW Beetles were equipped with 6 volts in their 1200 cc version. The 1300 cc Beetle was first equipped with a 12 volt system in 1968. The VW Bus and type 3 VWs were increased to 12 volts in 1967. Types 4 are in 12 volts, as they were only introduced to the market in the late 1960s.
measuring electric current To measure current, you must interrupt the circuit through which the current flows. The ammeter must be connected in series. Therefore, that a current clamp is a better solution. This type of ammeter does not affect the circuit to be measured, it measures the magnetic field around the conductor (induction principle, see edition 26).
DC versus AC A car needs a direct voltage of 12 V or 6 V to operate, a battery can only be charged by direct current. The alternator and dynamo generate alternating current. But what is the difference between AC and DC?
fuses Our oldest classic Volkswagen had a fuse box with four fuses, after that this was extended to eight. The most recent VW T25/T3 (Vanagon) Bus has more than twenty fuses. But what is the purpose of these fuses?
dynamo operating principal Wouldn`t it be nice to know what DF means, for example? And what does D+ mean? If you know what`s behind these letters and numbers, then connecting the dynamo will be a breeze. In this article, we will explain the working principle of the dynamo, also known as a direct current generator.
radio interference Have you ever driven a classic Volkswagen with an original radio or a classic radio, then you have probably ever known the phenomenon "interference". That annoying noise, buzzing, crackling that comes out of your speakers. These disturbances can have different causes, but they can also be remedied.